Hi this is Hutcho from Better Music, here
with the new Helix by Line 6, this beauty has been generating a lot of hype around the
world at the moment, and we’re lucky enough to have the only one in Australia here for
a demo just so I can show you a couple of the things that this can do, so I’ll just
run through a couple of the patches here and we’ll just see what sounds we’ve got. AC30 with a bit of trem. And a bit of a Plexi with a couple of, I think
maybe tube screamer and some delay. Alright guys so we’ll be expecting a whole
lot of these into the store shortly, so if you have any questions about it, just leave
some comments in the section below or come in the store and ask in person, more than
happy to answer anything you want to know. Thanks guys.

Line 6 Helix Guitar Effects Processor Unit – Sneak Peek | Better Music
Tagged on:                                                                                                                 

16 thoughts on “Line 6 Helix Guitar Effects Processor Unit – Sneak Peek | Better Music

  • August 10, 2015 at 11:35 am
    Permalink

    Did you run it into a PA or a combo?  It was really noisy…

    Reply
  • August 11, 2015 at 3:41 pm
    Permalink

    you got the only demo in AUS and you couldn't a) get the level loud enough to drowned out the plunk of your acoustic strings or b) make sure the mic didn't clip? 
    Hey Line6 – choose a better demo crew next time!

    Reply
  • August 13, 2015 at 3:04 pm
    Permalink

    I'd run it into the effects return next time to take out the color of the amp even more – and make sure you setup the Helix for that mode of operation so it sounds the best.

    Reply
  • August 15, 2015 at 3:25 pm
    Permalink

    can it nail shoegaze?

    Reply
  • August 15, 2015 at 4:50 pm
    Permalink

    Please run try to run it direct to an FR speaker or Effects Loop at the back of the guitar amp. It's too 'wet' with reverb too, so if it's possible to dial it down. we'll be waiting for more Amp sim demos. Thanks a lot, subscribing now.

    Reply
  • August 17, 2015 at 2:43 pm
    Permalink

    why is it noisy when plexi and drive engage?

    Reply
  • August 17, 2015 at 5:19 pm
    Permalink

    Hi I have a hd500x and the hi gain stuffs not great . Does this new unit sound better. Is it more inline with the axe fx and kemper

    Reply
  • August 18, 2015 at 5:30 am
    Permalink

    How many Noise gates can you set up in a chain? I like to use two.

    Reply
  • August 24, 2015 at 8:40 pm
    Permalink

    How would you compare the Helix to the Axe fx?

    Reply
  • August 25, 2015 at 7:51 am
    Permalink

    hello, the helix of your demo is connected to a sound system or a guitar amp?
     The three sounds are factory or programmed by you.
     Thank you

    Reply
  • September 3, 2015 at 10:40 pm
    Permalink

    $1500 for a pac man dispaly lol

    Reply
  • September 9, 2015 at 2:08 am
    Permalink

    debería afeitarse y ponerle un sm57 al gabinete para el próximo video.

    Reply
  • October 27, 2015 at 1:19 pm
    Permalink

    OMG is not the noise from the mic. I can make the difference between noise made by the mic and noise picked up by the mic.

    Reply
  • February 15, 2016 at 5:42 am
    Permalink

    Maybe a dingo ate your baby

    Reply
  • May 8, 2017 at 12:12 pm
    Permalink

    Bottom line… line 6 models suck flabby low end ass. Tried it and tried it and it sucks shit. Not even close to a quality tube amp growl, but other modelers are. Line 6 models the wrong preamp tubes. They sound like old cheap tube amps with bad transformers and shitty 12AX7s

    Reply
  • August 18, 2017 at 4:56 am
    Permalink

    Where the peak distort sound comes? The camera internal mic or the helix? Thanks

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *